1. Switch the cleaning program: Switch the program through the switch button in the upper right corner of the home page, and restart after power failure.
2.Replace the appropriate focusing lens: the cleaning range of lenses with different focal lengths is different, please choose according to the tips available for the model.
3.Remove the locking part in front of the gun head.
SUP23T needs to loosen the locking screw at the side to take out the chuck.
- cleaning process
Scanning frequency: swing speed of motor, ranging from 10 Hz to 10-100Hz, 80 is recommended.
Scanning width: the scanning width of the light spot depends on the lens specifications used by your model and is selected in the system settings.
Peak power: generally, it defaults to the maximum power of the laser.
Duty cycle: 100% by default
Pulse frequency: 2000 by default.
After setting the parameters, import and return, and you can see this process on the left side of the home page.
- Confirmation of focus
By scanning back and forth for a long distance, the focus is when the sound is the loudest and the spark is the biggest. At this time, cleaning should be carried out according to this distance, and the energy is the strongest.
According to the use of focusing, the following is a reference.
F150 focusing (generally, the distance from the gun head to the plate is about 10-15cm, and the energy is the strongest).
F400 focusing (generally, the distance from the gun head to the plate is about 35-40 cm, and the energy is the strongest).
F800 focusing (generally, the distance from the gun head to the plate is about 75-85cm, and the energy is the strongest).
- Use of gas
Selection of gas for cleaning: air is not less than 3kg, and oil-free and water-free or other inert gases are used for filtering above the third level.
When cleaning, please keep the distance between the gun head and the plate stable and the hand speed uniform.
Post time: 06-06-25
