Daily maintenance of industrial dust collector

Hello everyone, when we use industrial dust collectors, daily maintenance and maintenance are actually very important, and it is a very effective way to save money.

Now more and more factories have begun to use cartridge dust collectors. After a period of use, the cartridge dust collectors are very easy to be damaged. Although things will be broken sooner or later, if you maintain and maintain the industrial dust collectors regularly, it can be effective. increase the life of the filter cartridge and motor. If the filter cartridge in the dust collector is not cleaned in time, too much dust will adhere to the filter cartridge, which will increase the load of the motor and accelerate the aging of the motor and the filter cartridge. Therefore, regular maintenance and maintenance can effectively reduce unnecessary expenses.

So what do we need to do?
1. During the operation of the equipment, a special person should be set up to manage it and make a good work record.
2. Determine the amount of dust collected by the dedusting equipment and determine the ash discharge cycle according to the amount of dust collected by the dust removal system.
3. If the electromagnetic pulse valve fails, it should be removed in time. If there are impurities and moisture inside, it should be cleaned up. If the diaphragm is damaged, it should be replaced in time.
4. Always check whether the pulse cleaning system of the dust collector is normally blowing. If it is not normal, focus on checking whether the pulse valve diaphragm solenoid valve is malfunctioning or damaged, and it should be repaired or replaced in time.
5. Regularly check whether the operation of the equipment is normal according to the fluctuation of the operating resistance of the equipment.
6. Regularly check the use of wearing parts according to the list of wearing parts and replace them in time.
7. The dust collector and electronic control equipment must be operated and overhauled by special personnel. The operator must fully grasp the performance, structure and operation procedures of the dust collector, and deal with problems in time to ensure the normal operation of the system.
8. Regularly measure process parameters, such as flow, temperature, pressure, etc., if any abnormality is found, the cause should be found and dealt with in time.
9. When shutting down, after the process system is stopped, the dust collector and induced draft fan should continue to work without load for a period of time to remove moisture and dust in the equipment. It must be noted that when the dust collector stops working, the dust removal must be repeated repeatedly. The off-line dust cleaning operation is carried out by the filter, the dust on the filter cartridge is removed, and the dust and garbage are dumped in time to prevent the filter cartridge from being blocked by the influence of moisture.
10. When using the dust collector, it is forbidden to impact by external force.


Post time: 16-08-22